Folded Ribbon Rose Tutorial

I seem to be on a roll at the moment and I've been adding tutorials galore on my Craft Fairy Designs blog so I thought that I would add ... thumbnail 1 summary

14 years ago

I seem to be on a roll at the moment and I've been adding tutorials galore on my Craft Fairy Designs blog so I thought that I would add one here too.

You will need the shocking pink 23mm wide grosgrain for this and I used the swiss dot one as I wanted to have the contrast between the plain side and the dotty side. You can make a plain one if you want to but this looks kind of cute.

You will need to start by rolling a short section of the ribbon and securing it with a couple of stitches. Stitching is better than gluing as it will held in place and then, if you want to put it on a garment you can wash it without being afraid that it will fall apart. This roll will be your bud.

Next fold the ribbon at a 90 degree angle to the roll as shown below.

Roll the ribbon around the central bud until you get to the end of the folded part. It will be obvious when you do it. Secure the bottom with a couple of stitches. ,

Fold and roll again and again. See below. Make sure to put in a couple of stitches as you go.Below is what your rose should look like after you have folded a few times.

Now look at the back and you will see how this is coming along, and where to put the stitching.

Basically you keep on going until you have as many petals as you want. The cut you r ribbon and tuck the raw wdge under and tack into place. Turn over and your ribbon is done.